SHARP FO-2950M
Service Manual

FO-2950MGR/GH/MY/TH

[5] Maintenance
1. Scanning glass and rollers
Clean the scanning glass and rollers frequently to ensure that your transmitted images and copies are of the highest quality. Open the operation panel (grasp the panel release and pull up), and wipe the scanning glass, rollers and white backplate with a soft cloth. � Make sure that all dirt and stains (such as correcting fluid) are removed, as dirts and stains will cause vertical lines on transmitted images and copies. Document rollers

2 Grasp the finger hold on the toner cartridge handle where it is
marked PUSH, and pull the handle out. Rehold the handle and pull the toner cartridge out of the compartment. � Place the toner cartridge on a sheet of paper on a level surface.

White backplate

3 Grasp the tabs on the drum cartridge handle and gently pull the
cartridge out of the machine.

Scanning glass

2. The housing
Wipe the external parts and surface of the machine with a dry cloth. � Caution! Do not use benzene or thinner. These solvents may damage or discolor machine.

3. Cleaning the drum cartridge
If you find that characters or parts of an image are missing from your printed pages, the drum in the drum cartridge may need cleaning. Follow the steps below to clean the drum.

4 Take a sheet of clean paper and roll it into a tube. Roll it tightly so
that the diameter of the holes at each end is less than the thickness of your little finger.

1 Grasp the print compartment cover at both sides as shown, and
pull up to open the cover.

� Caution! The fusing unit inside the print compartment becomes very hot during operation. Do not touch the inside of the compartment or the paper guide on the underside of the print compartment cover.

5 Gently wipe the surface of the drum with the rolled-up paper to
remove any particles of toner caked on the drum. � Do not let the drum surface come into contact with anything other than the rolled-up paper. Fingerprints, water, alcohol, and other solvents will damage the drum surface. � Do not touch the drum surface with the edges of the rolled-up paper.

No good

1 � 11