|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thanks for a very good and readable servicemanual. Just what I needed as a "dinosaur technician". I really recommmend this site and will come back.
Åsbjörn
;
The manual I purchased was just what I needed. I was glad to find a site where I can find so many manuals on a wide variety of products.
;
The best diagram that I used in a long time. Everything was right on te money. It was easy and fast. Iwoiuld but again when I need a service manual.
;
The manual is great help for me, i'm happy to have it,thanks
 ;
Very pleased with manual except that a few more details in the drawings might make the job (not yet done, tut-tut) easier. Should be adequate though. Actually I didn't have to pay for this anyway as I was given credit for another item that wasn't quite complete. Good service, then.
UX-84TH FO-90TH/MY 4. Loading the fax paper (FO-20PRw)
� � Your fax machine prints incoming faxes on a special kind of paper called fax paper. The fax machine�s print head creates text and images by applying heat to the fax paper.
6 Insert the leading edge of the paperuntil the slot asout the opening in into shown. Continue to push the paper through the slot it comes
the front of the machine.
1Grasp the finger hold as shown and pull up to open the operation
panel.
7 Make sure the paper comes out straight, and then flip down the paper guide.
2Flip up the front paper guide.
2
1 Press the knob to make sure the front side of the metal guide is down.
8 Close the operation panel, making sure it clicks into place.
� A short length of the paper will be cut off.
3If you are loading paper that is 210mm in width, place the paper roll
� The ribbed side of the shims should face in (toward each other).
shims on each side of the paper compartment. (Note that Sharp recommended paper, including the initial roll, is 216mm in width.).
4Unwrap the roll of fax paper and insert the paper shaft. 5 Place the roll of fax paper in the compartment, making sure the ends
of the paper shaft fit into the notches on each side of the compartment. � Important: The roll must be placed so the leading edge of the paper unrolls as shown. (The paper is only coated on one side for printing. If the roll is placed backwards, the paper will come out blank after printing.)
YES
NO!
1�6
|
|
|
> |
|
