|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
 ;
Quick site processing. A complete and very useful manual with all details. Thank you!
;
Das Service Manual war von der ersten bis zur letzten Seite sehr informativ und hilfreich. Die Darstellung aller Teile war klar und der Text gut lesbar.
Vielen Dank, das war nicht der letzte Download bei ownner-manuals.com.
;
It's a grate service manuals.Have many details and the writing it's so clear.You have all you want in manual,nothing missing,belive me.I'm verry satisfied of this manual.
;
Great scanned service manual
Usefull informations.
I will buy again!
Best Regards
3-1
3-1
DISMANTLING HINTS
Dismantling of Front Dismantling of mono board
1) Remove front . See picture 1 2) Remove whole front (disconnect the wires on the mono board coming from front)
Service position monoboard
1) Bring front in position as shown in picture 6 2) Snap nok of front in bottom to make front stable . See picture 7 3) Connect front wiring back to monoboard. *The tuner module doesn't have to be connected. Use an other source (pe.CD)
Power rod 1 snap 1 1
1
snap 2 2 2 2 3
picture 3 picture 7
2
3) Remove 14 x screws shown in mentionned aria . See picture 3
snap snap
picture 1
1) Remove top cover 2) Remove power rod 3) Remove 6 x screw as shown in picture 1 4) Release two snaps (left & right side front) 5) Release two snaps on the bottom side front 6) Tipp down front as shown in picture 2
cable-sleeve
picture 6
Service position main trafo
1
1
1
1
1
1 1
1 2
Metal bracket 1 1
picture 4
picture 2
4) Remove wires out the cable-sleeve. 5) Remove 7 x screw and remove metal bracket 6) Remove 2 x screw on mono board . See pictue 4 7) Remove mono board as shown arrow 1 & 2 . See picture 4 8) Bring the mono board in the service position as shown in picture 5
picture 9 1) Put main trafo as shown in picture 9
Handling service cover Dismantling of mainstrafo
1 1 1
1
1 1
1 1 1 1
picture 5
Legend
1 1
1
1
1
picture 10 picture 8 1 2 = Torx M3x6mm ( screw with big head ) = Torx 3x10mm 3 = Torx M3x6mm 1) To open the service cover cut 14 x lugs between cover and bottem . See picture 10 ( 2) To close the service cover put 11 x screw in mentionned holes. See picture 10 Service codenumber 12x Torx M3x6mm screw with big head = 4822 502 14659
PCS 102 488
1) Remove power rod 2) Remove 4x screw as shown in picture 8
)
|
|
|
> |
|
