|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent service from this company (including a total refund on an earlier purchase when through no fault of the company the manual was incomplete). I have purchased several manuals which I have been very satisfied with, as I am with this one. Highly recommended.
 ;
It was easy to order and received exactly what I needed. Only complaint would be the 24 hours you have to wait.
;
Manual was delivered in a timely manner and was all in English as advertised. The manuals I received when we moved into our flat were in German, Italian, and French. Having never used a steamer before, and not speaking/reading German very well, I needed an English Manual. this was a huge help.
;
Great Manual. This manual is available no where else. It was exactly what I was looking for. Only in German.
;
This GRUNDIG UV5A Owner Manual is not only an instruction manual but a total functional circuit description of the Multimeter and includes circuit diagram at the end pages. It is very helpful for repairing and calibrating the instrument. It is written in two languages English and German for international support. It was very easy to repair my unit with this document. Regards, Regis Pauly, Electrical Engineer.
31502002GB.fm Page 14 Thursday, April 27, 2006 2:54 PM
WATER FILTER MONITORING AND REPLACEMENT FUNCTION (ON SOME MODELS)
Water filter indicator light function (if present) At the time of purchase of the product and after replacement, the filter symbol in green. The filter symbol can become red according to product use and the natural depletion of the filter charge. When a new filter is required, the the symbol on the display turns yellow (99% of filter life has been used). Important: The filter must only be replaced when the symbol on the display is red. At this point the filter cartridge must be replaced. Replace the filter cartridge, then press the RESET button until the system has reset with the symbol becoming green. Note: The RESET button does not work when the filter indicator light is green. Appliances with an ice maker or water dispenser must be connected to a water supply which delivers potable water only. Ice makers and/ or water dispensers not directly connected to a mains water supply must be filled with potable water only.
CHANGING A WATER FILTER CARTRIDGE
The water filter is situated under the freezer compartment door. 1. Locate the water filter cartridge cap in the front base grille below the freezer compartment door. Rotate the cap counterclockwise to a vertical position and pull the cap and filter cartridge out through the base grille. NOTE: Since there is water in the cartridge, some spilling may occur. 2. Remove the cartridge cap by sliding it off the end of the old cartridge. The cap will slide to the left or right. DO NOT DISCARD THE CAP. 3. Take the new cartridge out of the pack and remove the protection from seals. 4. Slide the cartridge cap onto the new cartridge as shown. 5. With cartridge cap in the vertical position, push the new filter cartridge into the base grille until it stops. Rotate the cartridge cap clockwise to a horizontal position. 6. RUN WATER THROUGH THE DISPENSER UNTIL THE WATER RUNS CLEAR (about 9-14 litres or 6-7 minutes). This will clean the system and clear air from the lines. NOTE: as air is cleared from the system, water may spurt out of the dispenser. Ordering replacement filters To order other water filter cartridges, contact authorised Whirlpool dealers.
1
2
3
4
5 14
|
|
|
> |
|
