|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It is pretty good. The schematics were covered all components, the manual also provide the parts list . It's useful for the trouble shooting.
 ;
Very fast service, best quality of the service manual and the schematics
;
This service manual of the old video cassette recorder VT-LC50EM is very good readable even the tiniest numbers (i.e. IC-pins). The circuits are very clear. Many details of the schematic are very good described but in GERMAN language. Many schematic details - but complete at all. Common background information of several details are enclosed and physical knowledge of the TFT liquid crystal display for example. The manual lacks PCB drawings. If you understand german I would recommend this manual for you.
;
Hi, this is a very clear manual, nice copy, not quite up to the standard of the very best available but better than many others. I think the price was especially fair for a hard to find manual and I would certainly use this manual seller again. Recommended.
;
This schema available for me in good condition. I would highly recommend.
FS-SD998V/FS-SD778V FS-SD558V
6. Pull out the CD mechanism assembly from the three shafts of the CD mechanism cover in the direction of the arrow. ATTENTION: When reassembling, confirm that the cushion of the CD mechanism assembly is reattached to the three shafts. 7. Remove the CD mechanism board from the CD mechanism cover. CAUTION: When reassembling, unsolder the short circuit round after connecting the flexible wire to the connector.
CD mechanism board Shafts CD mechanism cover
Fig.39
Jack board
W
Removing the jack board (See Fig.40)
Prior to performing following procedure, remove the CD mechanism board. 1. Disconnect the wire from connector CN502 on the jack board. 2. Remove the two screws W attaching the jack board.
CD mechanism board CN706
Switch board
W X
CN502
X
Fig.40
Removing the switch board (See Fig.41)
Prior to performing following procedure, remove the CD mechanism board. 1. Disconnect the wire from connector CN502 on the jack board. 2. Remove the six screws X board. attaching the switch
Tabs d
Fig.41
Removing the LED board (See Fig.41 and 42)
1. Disconnect the harness from connector CN706 on the CD mechanism board on the underside of the CD mechanism base assembly. 2. Push inward the two tabs d attaching the LED board case and release them. 3. Pull out the LED board from the LED board case.
LED board
LED board case Fig.42
1-13
|
|
|
> |
|
