|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
;
The manual was properly scanned and perfectly readable. The only small problem is that I couldn't use my dear Ctrl + F to find a word I needed.
;
Nothing wrong with the manual or the delivery - came to me the same day I ordered it. But afterwards I realized that I ordered the wrong manual. Probably better with the Quick start - version. So maybe it would be better if we could see a list with inhold for each manual before ordering?
 ;
Bought T4850 High End Tuner a few years ago, but i didn't know where all the buttons were used for. So i purchased the owners manual. Perfect! Just what i needed.
;
Bought the used Philips car-radio. No manual! Found on this site a copy of the orginal English manual. I am very happy with it. Now I know how to setup and use my "new" car-radio.
Recommended site for everybody looking for a manual for (older) products!
RX-6030VBK
2.7 Removing the audio board (See Fig.9) � Prior to performing the following procedure, remove the top cover, rear panel, component video board, DSP board, audio input board, DVD board, video board, S Video board and tuner board. (1) From the top side of the main body, disconnect the card wire from the connector CN402 on the audio board. (2) Disconnect the relay board from the connectors (CN291, CN491) on the power supply board and audio board. (3) Disconnect the wires from the connectors CN471, CN472 and CN473 on the audio board. (4) Remove the three screws H attaching the audio board. (5) Loosen the screw J attaching the audio board.
CN472
Relay board
Power supply board CN291
CN471
CN473 Card wire
H J
Audio board CN402
CN491
H
Fig.9
2.8 Removing the speaker terminal board (See Fig.10) � Prior to performing the following procedure, remove the top cover and rear panel. (1) From the top side of the main body, remove the solders from the soldered sections a on the speaker terminal board.
Parallel wires
Soldered sections a Speaker terminal board Fig.10
(No.22026)1-7
|
|
|
> |
|
