The ease of this purchase was a good start. The content of this manual was exactly all I needed to retore my Tandberg 64.
All of the mechanical and electrical information is contained in the manual and the quality of the document makes reading the data easy.
The exerience with the resource has made this my prime source for technical data.
Owner-manuals.com is the best Possibility to give vantage HIGH CLASS Elektronic COMPONENTS
a new Life.Thanks alot for your perfekt Service.
Text excerpt from page 86 (click to view)
July 1, �85
6D-8. By-pass Feed Table Removal 1. Open the front cover and remove the front inner cover (4 screws). [FT3020] Open the front cover, push the slide unit to the left, and remove the inner cover (5 screws). [FT3050/FT3060] Remove the E-ring from the front shaft of the by-pass feed table. Remove the right rear cover (2 screws) Open the by-pass feed table and remove the inner cover and the toner tank cover (2 screws). Remove the rear cover (2 screws) and the main PCB (2 screws, 4 connectors). [FT3020] Remove the rear cover (2 screws) and the optics PCB (1 screw, 4 connectors). [FT3050/FT3060] Remove the stud screw from the rear side. Take off the by-pass feed table. [FT3020] (1 connector, 1 bushing) [FT3050/FT3060]
CAUTION: When reinstalling, do not damage the cassette arm release lever nor the bypass feed table sensor.