|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
 ;
The manual was exact the thing that was promised. My old car stereo is working again thanks to the information supplied.
;
I PURHASED THIS PRODUCT BECAUSE I WAS HAVING PROBLEMS WITH MY CDR20 HARMAN KARDON RECORDER. WHICH I PURCHASED NEW 12 YEARS AGO. AFTER REVIEWING THE MANUAL, I WAS ABLE TO ADJUST THE TENSIONER IN THE SYSTEM. WORKS LIKE A CHAMP!.
SAVED ME AT LEAST 100.00 WHICH WAS WHAT A SERVICE REPAIR STATION WANTED. GREAT MANUAL EASY TO READ. SPECIALLY AFTER I PRINTED THE PAGES WHICH DEALT WITH MY RECORDER. THANKS A LOT!!!!!!!!
;
You can fully trust on this one!
All the schematics are very crear an in one piece per page
;
I have never bought a service manual which is as competely readable as this althogh it was a scanned pdf. Thank you for this succesful manual also cheaper than other sites.
FUSING
15 January 1992
7.5 FUSING LAMP REPLACEMENT
[E] [D] [B] [C] [H]
[F]
[A] [G] 1. Make sure that the main switch is turned off and the power supply cord is unplugged. 2. Open the front cover and remove the upper inner cover (3 screws). 3. Remove the cleaning unit. (See Cleaning Unit Removal.) 4. Open the upper unit by pushing release lever. 5. Remove the lower inner cover (5 screws). 6. Remove the fusing cover [A] (1 screw). 7. Remove the thermoswitch bracket [B] (1 screw). 8. Disconnect the connector [C] of the fusing lamp from the thermoswitch. 9. Remove the upper rear cover (2 screws) and lower rear cover (2 screws). 10. Remove the ac drive board cover (2 screws). 11. Remove the ac drive board bracket [D] with the ac drive board [E] (2 screws and all ac harness connectors). 12. Remove the rear support bracket [F] (1 screw). 13. Pull the fusing lamp [G] out the front end of the hot roller. NOTE: a) Do not touch the fusing lamp with bare hands. b) Slide the new fusing lamp into the hot roller through the opening at the front of the roller. c) Make sure that the fusing lamp insulators [H] (front and rear) are properly set in the holders as shown.
5-76
|
|
|
> |
|
