|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
 ;
Très-très bon site, facile, très bon prix.
Au futur besoin, je n’hésiterais à faire appel à vous.
Merci
;
This is the correct service manual of SHARP RX-100H(BK) DAT.
;
The ervice manual for my 1982 Kenwood KR-1000 receiver is great! Full detail on all circuits with part number detail. I will definately be ordering more manuals for my other vintage equipment! Order was fulfilled quickly! Very efficient ordering process! Thnaks for your help! Great site!
20 December 1996
COPIER (A219)
[B]
[C]
[F]
Installation
[E] [A]
A219I502.wmf
[D]
[G]
A219I503.wmf
4. Turn the "B1" lever [A] counterclockwise to lower the transfer corona unit. 5. Remove the knob screw [B] and gently pull out the imaging unit [C]. Then place it on a clean sheet of paper. 6. Remove the cover [D] from the imaging unit (1 screw and 1 snap [E]). 7. Pour in the developer [F] evenly into the imaging unit. Then rotate the outer gear [G] for one or two turns to distribute the developer as shown. NOTE: When installing new developer or manually rotating the development roller, always make sure to turn the gear in the direction shown above. Also do not rotate the gear more than 3 turns to prevent damage to the unit. 8. Remount the cover on the imaging unit, and install the unit in the copier (1 knob screw). Then turn the "B1" lever clockwise to raise the transfer corona unit.
3-5
|
|
|
> |
|
