|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
;
Great Job!!! clear and efficient as always!!
it is really nice to have peple that are doing such a good work!!!!!
;
I must admit, I was very skeptical... $4.99 for a 74 page service manual. I've seen some very poorly scanned manuals on the Internet, but this one is VERY good quality! Even when zooming into 500%. Great Deal!
;
Very good detail, Quick service response. A useful service manual with all details. I recomend this service.
;
As Always you can find here manuals even of difficult TV scheme which are scan in almost perfect way.clear and fast!!!!!
Great work thanks!
31 October 1995
CLEANING
4.4 ENTRANCE SEAL REPLACEMENT
[A] [B] [D] [E] [E]
[E]
[K] [F]
[C] [K]
[L]
1.5±0.5mm
[N]
[G]
[H]
[F]
[I]
[J]
[M]
A173R545.img
1. Remove the cleaning unit and cleaning blade. (See Cleaning Blade Removal.) 2. Remove the used toner. 3. Clean the cleaning unit with a vacuum cleaner. 4. Remove the entrance seal [A] together with the strip of two-sided tape [B] and both of the two-sided seals [C] which secure the entrance seal [A] to the lower casing [D] and the side seals [E]. 5. Clean the lower casing [D] with alcohol. Make sure that no tape remains on the casing surface and the side seals. 6. Place a new strip of two-sided tape [F] on the lower casing surface as shown in the illustration. The side edge [G] of the tape must be flush with the edge [H] of the lower casing and the lower edge [I] of the tape must be flush with the top of the projection [J] of the lower casing as shown in the illustration. 7. Place new strips of two-sided seals [K] on the side seals [E] at both sides. 8. Place the new entrance seal [L] on the two-sided tape [F] and the two-sided seals [K] as shown in the illustration. NOTE: a) The lower edge [M] of the entrance seal must be aligned with the edge [J] of the projection of the lower casing. b) Make sure that there are no waves in the upper edge [N] of the entrance seal.
5-33
|
|
|
> |
|
