|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
High-quality scanning. Detailed description. Recommend for all technician. A+++
;
This is a good quality scan of the original Service Manual from Nordmende, Germany. Contains the circuit diagram, PCB layout, adjust/tune instructions as well. It is NOT in English but in GERMAN language! That was quite right for my german friend from the lower east side in Berlin.
 ;
Received via e-mail this PDF manual is worth the money. This is a quality scan of a manual in excellent condition and is just as good as having the original manual in hand. I have later seen the original manual and it was printed in colour, but this particular manual is black & white but scan resolution is high end quality! All drawings and pictures are presented in great detail. So, nearly perfect score in my opinion.
If you own the turntable you also should own the manual!
;
I was very satisfied with the service manual I ordered and downloaded. I will definitely buy again from this seller.
;
Great product. Recieved it fast...exactly as advertised.
1 May 1993
PAPER FEED
5.11 3RD PAPER FEED CLUTCH REPLACEMENT (A111 Copier Only)
[G] [F]
[B] [H] [C]
[A]
[E]
[D] [I]
1. Turn off the main switch. 2. Remove the rear cover (4 screws). 3. Unhook the spring [A] from the tension pulley bracket [B]. 4. Remove the drive belt [C] from the drive pulley [D]; then remove the pulley (1 E-ring). 5. Remove the 3rd paper feed clutch bracket [E] (2 E-rings and bushings and 3 screws). 6. Replace the 3rd paper feed clutch [F] (1 connector). NOTE: a) When the clutch is installed, make sure that the stopper [G] on the bracket fits into the slot on the clutch as shown. b) When the clutch is installed, make sure that the 3rd feed rollers are facing up. If not, rotate the shaft [H]. c) When the drive belt is installed, make sure that the belt stoppers [I] of the drive pulleys are positioned correctly as shown. This is to prevent the drive belt from coming off the pulleys.
Replacement Adjustment
5-53
|
|
|
> |
|
