|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
More than pleased with my prurchase, very good product for the price.
;
This is a good quality scan of the service manual which includes an assembly diagram, block diagram, schematic, and parts list. Exactly what is needed to repair my KR-V55R receiver.
;
Excellent concise manual. All needed information was included. Typeface and diagrams were clear. Very fair price considering what others are charging. Many thanks
 ;
Response is a little slow- I had to wait 12 hours to receive download link but it says that it may take up to 24hrs.
Manual is old and was not produced in PDF- scanned copy is exellent.
Overall- value for money- I recommend
;
Excellent quality and quickly delivered manuals at a fair price. Great care is taken in the reproduction process. Even photographs and highly detailed drawings are as clear as in the original. That cannot be said for some freelance manual copies I have obtained from the web. If you have exhausted your internet search of technical manuals, try Owner-Manuals.com. If they do not have it, I do not think it exists. Perhaps, if requested, they may be able to find it. Their resources are certainly greater than most. Shopping here certainly beats waiting for months or years for the manual you seek to appear in an internet auction or garage sale.
28 February 1989
1. Position the blue wire [1] as shown in the figure (opposite the Allen screws) and wind it halfway around the pulley. (The upper half of the round ball at the end of the wire should be in the hole.) 2. Position the silver wire [2] in the hole on the Allen screw side. 3. Wind the blue wire six times and the silver wire six and a half times, as seen from the opposite side of the Allen screw. (Do not count the one half turn on the blue wire from step #1, and make sure to make the extra wrap on the silver wire.) 4. Position the blue wire [3] in the hole on the Allen screw side and wind it halfway around the pulley. 5. Position the silver wire [4]. 6. Wind the blue wire [3] one and a half times and the silver wire [4] once. NOTE: a) The blue and silver wires alternate on the pulley (blue uppermost). b) The wires are not wound on two of the grooves of the pulley as shown above. 7. Clamp wires onto pulley wires with the fixing jig [A]. 8. Set the scanner pulley on the shaft and tighten 2 Allen screws. NOTE: Maintain 1 mm of clearance as shown in the above figure. As the thickness of the scale is about 1 mm, put it between the pulley and the motor and tighten the Allen screws.
5-12
|
|
|
> |
|
