|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I had been looking everywhere for a proper service manual for this VCR. Everywhere else that has this available for download has a very light version. This is the full service manual with all aspects that would interest anyone looking for the service manual for the AIWA HV-MX100 Worldwide VHS VCR. Great quality (as always). A winner hands down. Best Quality.
;
Top quality manual. Covers all aspects you'd expect in a top quality service manual for this Panasonic VHS VCR. The manual resolution is high. Another top quality manual from the only site worth downloading manuals from! If you're looking for a manual for the PV-9662 VHS VCR, this is the one you'll want to get!
;
complete part-lists and pcb layout, schematic diagram is good enlargable,
;
Excellent, fast delivery, excellent product. Good luck!
;
This manual is for the usa model only. But it is clear
, accurate and comprehensive, including board layouts and schematics.
I found it extremely useful for my mitsubishi dp-86da, but the same diagram would also work for the realistic lab5000 and hi fi 80. Thanks.
31 January �89
CLEANING BLADE
The cleaning pressure mechanism is shown above. When the cleaning solenoid [A] is energized, it turns the cleaning solenoid lever [B] clockwise (rear view). Due to the pull of the cleaning blade pressure spring [C], the pressure arm [D] also turns clockwise and pushes the cleaning blade lever [E] up. The cleaning blade holder then rotates and the cleaning blade [F] presses against the drum. The pressure spring limits the blade pressure. The cleaning blade is mounted by a single swivel screw [G] at its exact center of gravity. With this type of mounting the blade sets parallel and applies even pressure automatically, Also since pressure is transmitted in the center, a single pressure spring is used. Side-to-side movement is applied to the cleaning blade to prevent uneven wear and ensure efficient cleaning. The blade scraper [H] is mounted in contact with the bottom of the cleaning blade. When pressure is applied to the cleaning blade, it is forced forward and bends at its outer edge. When pressure is released from the blade, it snaps back to its original shape. At this time, the blade scraper [H] scrapes off the excess toner and paper dust from the edge of the blade. This helps to maintain efficient cleaning. The blade pressure is released when there is no key input for 15 minutes, when a paper misfeed occurs, or when the safety switches are open. The blade scraper also prevents toner from scattering inside the copier by keeping toner inside the cleaning unit.
2-57
|
|
|
> |
|
