|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
 ;
We received the manual in a timely manner and it was exactly what we were expecting.
;
Excellant, finally this is want I need and searching for The service manual is fantastic and thank you to owner-manuals.com and its service. Price is reasonable. It's a bit slow on my end in downloading but manage to receive the whole manual without a break. once again, thanks.
;
Very good scanning quality. All schematics are very legible. Worth every cent !
12 February 1992
COPIER INSTALLATION
[C]
[B]
[C]
[A]
[D]
Installation
[E]
[F]
11. Push the development unit lock lever [A] to the right (to the lock position). 12. Move the development release lever [B] to the right and pull out the black development unit [C] half way. Holding the toner supply unit [D] with your right hand and the bottom of the development unit with your left hand, pull the unit all the way out . Place the unit on a clean sheet of paper. 13. Separate the toner supply unit from the development unit (3 screws). 14. Pour one pack of black developer [E] into the development unit while turning the development roller knob [F] counterclockwise. This will distribute the developer inside the unit. 15. Remount the toner supply unit on the development unit.
3-7
|
|
|
> |
|
