|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
no problems with the purchase of a circuit diagram
;
Scan are good quality and overall just what i was looking for. Thanks!
 ;
Very good quality pdf file, no missing pages and all words and schematics clearly readable. Whole manual is present featuring different languages.
;
Very,very good manual.It was very explicit and readble.It was helpfull.Thanks.
;
The service manual is scanned, but high quality, high resolution. The smallest texts on schematics diagram is readable. Super! Thank you!
DEVELOPMENT AND TONER SUPPLY
13th January 1995
4. Pour about half a pack of developer [E] into the development unit. Then rotate the two outer gears [F] and [G] as shown to distribute the developer evenly. Then pour in all the remaining developer and rotate the gears again. NOTE: Do not rotate the gears in the other direction, or developer will spill out. 5. Remount the toner supply unit on the development unit (2 screws) and reconnect the connector. NOTE: Make sure that the positioning rib [H] sits in the groove [I]. 6. Install the development unit in the copier (1 knob screw and 1 connector). 7. Turn on the main switch, then perform the TD sensor initial setting for new developer using SP2-214.
!
CAUTION Never make any copy with the new developer before completing the TD sensor initial setting (SP2-214). Otherwise toner density control will be abnormal.
5-14
|
|
|
> |
|
