|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Dear Sirs,
Thank you for the fast support, the manual does provide all necessary information to repair the radio. All schematics are in a good quality for reading.
The manual fits 100% to my requirements as a technican.
Kind regards Thomas
;
the big video recorder format s-vhs many features delicate in loading system of the cassette. Such machines are no longer manufactured, it would be too expensive.
 ;
THIS MANUAL IS VERY GOOD AND VERY CLEAR
PLEASE NOTE IT DOES NOT CONTAIN THE SETUP INFORMATION TO ALIGHN THE GEARS IN THE CD MECH IT DOES SHOW ALL THE PARTS AND THEIR LOCATIONS .
;
Complete service and operation manual. All schematics are there, all circuit boards AND add-on boards. Including exploded views ,component names and specifications. Also electrical and mechanical adjustment procedures are in this manual. This manual also covers the more advanced BR-S811E unit. Scan quality is fair and usable.
;
High quality scan of original Service Manual. Everything´s fine!
7. The voice of the caller cannot be heard (incoming call).
Can the base and handset be connected? OK The 1kHz 97.5mV sine waveform is applied to TEL-line of the base, can the 1kHz sine waveform from the Q1 collector be fed? OK Check whether there is the 1kHz sine waveform at Pin13 of IC1. OK Check whether there is the 1kHz sine waveform at Pin9 of IC1. OK TX output signal from the base is detected by the liner detector, can the 1kHz 3kHz Dev. sine waveform be fed? OK Check whether there is the 1kHz sine waveform at Pin16 of IC501. OK Check whether there is the 1kHz sine waveform at Pin19 and 20 of IC501. OK Check whether there is the 1kHz sine waveform during for Pin1 and 2 of J501. OK NG NG Check IC501 and Pin17~20 peripheral circuits of IC501. NG Check IC501 and Pin15~16 peripheral circuits of IC501. NG NG Check IC1 and Pin9~11 peripheral circuits of IC1. NG Check IC1 and Pin13~14 peripheral circuits of IC1. NG Check the base TEL-line circuit and RELAY control circuit. NG See 3. The base and handset be cannot be connected.
Check C65 and R51.
Check J501 and its soldering.
Check SP801 and WA801.
19
|
|
|
> |
|
