|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good quality original datasheet!I like this amazing website!!!!!!
 ;
Excellent just what I needed to replace the electrolytic caps and make this old gem a beauty again. Was as scan of the original photocopied service manual.
;
It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
;
I want to give you a real heads-up for your desire to enable such people as I to acquire the information I need to maintain the older types of equipment such as this Akai HXA351W. You do a swell job with all the processes you have to perform so I can have a legible, thus usable
document which does not send me crazy trying to figure out the blurry text of a bad copy.
Very well done, Thomas.
;
This manual is very well presented and after printing out looks about as close to an original as I think you can get. The quality is second to none.
The content of the manual is comprehensive and I think it would be well suited to an audio repair professional which I'm not but I did find it very informative and helpful.
The cost of the manual is more than covered by the money I'll save when I change the keep memory battery now I have the relavant info.
Very pleased with my purchase and can recommend it wholeheartedly as I can other manuals I've downloaded from this site.
Regards
Limey Alex
7. The voice of the caller cannot be heard (incoming call).
Can the base and handset be connected? OK The 1kHz 97.5mV sine waveform is applied to TEL-line of the base, can the 1kHz sine waveform from the Q1 collector be fed? OK Check whether there is the 1kHz sine waveform at Pin13 of IC1. OK Check whether there is the 1kHz sine waveform at Pin9 of IC1. OK TX output signal from the base is detected by the liner detector, can the 1kHz 3kHz Dev. sine waveform be fed? OK Check whether there is the 1kHz sine waveform at Pin16 of IC501. OK Check whether there is the 1kHz sine waveform at Pin19 and 20 of IC501. OK Check whether there is the 1kHz sine waveform during for Pin1 and 2 of J501. OK NG NG Check IC501 and Pin17~20 peripheral circuits of IC501. NG Check IC501 and Pin15~16 peripheral circuits of IC501. NG NG Check IC1 and Pin9~11 peripheral circuits of IC1. NG Check IC1 and Pin13~14 peripheral circuits of IC1. NG Check the base TEL-line circuit and RELAY control circuit. NG See 3. The base and handset be cannot be connected.
Check C65 and R51.
Check J501 and its soldering.
Check SP801 and WA801.
19
|
|
|
> |
|
