|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It took about 24-hours after my payment before I was able to get to the download. Apparently, payment processing is not 100% automated. That is no big deal, just be aware of that going in.
After I got to it, it was in good shape, easy to read, etc. Not some cheap FAX copy looking thing.
Also, this site was the cheapest I found. Another Plus!
 ;
Good price, very legible manual, exactly what I needed -- but had to wait a day to actually get the download of the manual. Would have preferred to download it immediately after payment rather than waiting for someone to "process" my order. I was surprised that I had to wait that long.
;
As the only source for this manual it rather rank quite high since it is well scanned and perfectly readable.
;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
DO NOT CHANGE ANY MODULE UNLESS THE SET IS SWITCH OFF The mains supply side of the switch mode power supply transformer is live. Use an isolating transformer. The receivers fulfill completely the safety requirements. Safety precautions: Servicing of this TV should only be carried out by a qualified person. - Components marked with the warning symbol on the circuit diagram are critical for safety and must only be replaced with an identical component. - Power resistor and fusable resistors must be mounted in an identical manner to the original component. - When servicing this TV, check that the EHT does not exceed 26kV. TV Set switched off: Make short-circuit between HV-CRT clip and CRT ground layer. Short C804 (150mF) before changing IC802 or other components in primary side of SMPS. Measurements: Voltage readings and oscilloscope traces are measured under following conditions. Antenna signal 60dB from colourbar generator. (100% white, 75% colour saturation) Brightness, contrast, colour set for a normal picture. Mains supply, 220VAC, 50Hz.
PERI-TV SOCKET
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21
SCART 1 (SC050) Audio right output 0.5Vrms / 1K Audio right input 0.5Vrms / 10K Audio left output 0.5Vrms / 1K Ground AF Ground Blue Audio left input 0.5Vrms / 10K Blue input 0.7Vpp / 75ohm AV switching input 0-12VDC /10K Ground Green Green input 0.7Vpp / 75ohm Ground Red Ground Blanking Red input 0.7Vpp / 75ohm Blanking input 0-0.4VDC, 1-3VDC / 75ohm Ground CVS output Ground CVS input CVS output 1Vpp / 75ohm CVS input 1Vpp / 75ohm Ground
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21
SCART 2 (SC051) Audio right output 0.5Vrms / 1K Audio right input 0.5Vrms / 10K Audio left output 0.5Vrms / 1K Ground AF Ground Blue Audio left input 0.5Vrms / 10K Blue input 0.7Vpp / 75ohm AV switching input 0-12VDC /10K Ground Green Ground Red Ground Blanking Ground CVS output Ground CVS input CVS output 1Vpp / 75ohm CVS input 1Vpp / 75ohm Ground
11Ak41 is a 100Hz flicker free colour television capable of driving 28�4:3/16:9, 33�4:3 and 29�4:3 real flat picture tubes. The chassis is capable of operation in PAL, SECAM, NTSC (playback) colour standards and multiple transmission standards as B/G, D/K, I/I�, and L/L´. Sound system output is supplying 12W (10%THD) for left, right and center outputs of 8ohm speakers, and 2 x 7W for surround outputs of 2 x 4ohm speakers, connected in series. TV supports the level 1.5 teletext standard. It is possible to decode transmissions including high graphical data. The chassis is equipped with one full EuroScart, one other SCART for AV input/output, one front-AV input, one back-AV output, one headphone output, one SVHS input (via SCART and SVHS connector), one VGA input, two external speaker outputs (left and right), one centre speaker output, and one surround speaker output for two speakers in series.
2
INTRODUCTION
|
|
|
> |
|
