|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Absolutely perfect! I've been trying to understand how to use all or at least some of the features of the receiver and especially the remote.
;
Copy of genuine owners/operators manual, very useful
;
The manual was a perfect match and was exactly what I was looking for. I'm very satisfied with my purchase.
;
Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
;
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
RECORDING
Dubbing tapes (from tape deck 1 to
tape deck 2) 1 Press TAPE ( TAPE 1�2 ) to select tape deck 2. 2 Load the prerecorded tape into tape deck 1 and a blank tape into tape deck 2. � Make sure the tape in tape deck 1 has its full spool to the left. 3 (For Tape Deck 2 only) Press SIDE on the remote control to select the recording side. 4 Press DUB (HSD) once for normal
speed dubbing or twice (within 2
� You can listen to another source while dubbing. � Dolby NR button has no influence during dubbing (dubbing from tape deck 1 to tape deck 2). An original tape recorded with Dolby B NR automatically produces a copy with Dolby B NR.
English 22
Recording the mixed sound / One Touch Recording
� During microphone mixing, you can record the mixed sound on a tape in tape deck 2 except dubbing mode. � For One Touch Recording, as soon as you press REC, the current source (CD, TUNER or AUX) will be recorded on tape deck 2 1 Load a blank tape in tape deck 2. 2 Press REC to start recording. � The REC flag starts flashing. 3 Press � to stop recording.
seconds) for high speed dubbing. � �NORMAL� (normal speed) or
�FAST� (high speed) will be displayed, followed by �DUBBING�. � The HSD flag appears on the display during high speed dubbing. � Dubbing will start immediately. � The REC flag starts flashing. 5 Press � to stop dubbing.
Notes: � At the end of side A, flip the tapes to side B and repeat the procedure. � Dubbing of tapes is only possible from tape deck 1 to tape deck 2. � To ensure good dubbing, use tapes of the same length. � During high speed dubbing in Tape mode, the sound is reduced to a low volume.
Note: � When you press RECORD while in TAPE mode, "SELECT SOURCE" will be displayed. One Touch Recording is not possible in TAPE mode.
Digital Recording via Digital Out
For CD digital recording, please refer to the Instructions Manual of the CD Recorder, digital audio equipment, etc.
|
|
|
> |
|
