|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
;
The manuel was exactly what I needed and I received it promptly. Thanks
;
Thanks to Owner-Manuals.com! This manual was exactly what I needed. As Amana was purchased by Maytag and later by Whirlpool, there was no way to receive it from their websites. I was lucky to find this resource.
Radio Reception
Tuning to radio stations 1
Press STANDBY-ON to on, then press TUNER�BAND to select TUNER mode. � Display: the waveband, radio station frequency and if programmed, a preset number are shown.
Storing preset radio stations
You can store up to 32 preset radio stations in the memory (20 FM and 12AM).
E n g l i s h
1 2
Tune to your desired radio station (see �Tuning to radio stations�). Press PROGRAM to activate programming. (or PROG on the remote control) � Display shows: current radio frequency and CH. -- flashes for you to enter a preset number.
2 3
Press TUNER�BAND once or more to select your waveband: FM or AM (MW). Press and hold 4 or ¢ until the frequency in the display starts running. � The radio automatically tunes to a station of sufficient reception. � If a FM station is received in stereo, STEREO is shown.
3 4 5
Press PRESET�REPEAT to select a preset number. Press PROGRAM to confirm. Repeat steps 1-4 to store other stations. Helpful hints: � You can erase a preset station by storing another frequency in its place. To listen to a preset station
Repeat step 3 if necessary until you find the desired radio station. � To tune to a weak station, press 4 or ¢ briefly and repeatedly until optimal reception is found. � To tune to a weak FM station, press STEREO�MONO once or more until MONO appears on the display.
4
� Either press PRESET� REPEAT once or more until the desired preset station is displayed. � Or press digits 0 - +10 on remote control to select the desired preset station. e.g. Preset 3: Press 3 Preset 10: Press +10 and then, 0 Preset 13: Press +10 and then, 3 Preset 20: Press +10, +10 and then, 0.
STANDBY-ON
16
|
|
|
> |
|
