|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
;
The manuel was exactly what I needed and I received it promptly. Thanks
;
Thanks to Owner-Manuals.com! This manual was exactly what I needed. As Amana was purchased by Maytag and later by Whirlpool, there was no way to receive it from their websites. I was lucky to find this resource.
 ;
Great to be able to set channels again, on an old but stoll fine working TV
Connections
WARNING!
� Use only the supplied speakers. The combination of the main unit and speakers provide the best sound. Using other speakers can damage the unit and sound quality will be negatively affected. � Never make or change connections with the power switched on. � Connect the AC power cord to the power outlet only after you have finished hooking up everything.
Step 3:
Connecting to game console
E n g l i s h
IMPORTANT!
Gameport inputs are solely for game console only. a. Use the game console�s video cable (not supplied) to connect its video output to the GAMEPORT-VIDEO terminal. b. Use the game console�s audio cables (not supplied) to connect its audio outputs to the GAMEPORT-AUDIO L. / AUDIO R. terminals. c. Use a video cable (yellow) to connect the VIDEO OUT terminal to the video input on the TV for viewing. Notes: � On the TV, the Video Input jack is usually yellow and might be labeled A/V In, CVBS, Composite or Baseband. � To avoid magnetic interference, do not position the front speakers too close to your TV.
Step 1:
Connecting FM/AM antennas
� Place the AM loop antenna on a shelf or attach it to a stand or wall. � Extend the FM antenna and fix its ends to the wall. � Adjust the position of the antennas for optimal reception. � Position the antennas as far as possible from a TV, VCR or other radiation source to prevent unwanted noise. � For better FM stereo reception, connect external FM antenna.
Step 4: Step 2: Connecting the speakers
Connecting the AC power cord
Connect the speaker wires to the SPEAKERS terminals, right speaker to "R" and left speaker to "L", colored (marked) wire to "+" and black (unmarked) wire to "-". Fully insert the stripped portion of the speaker wire into the terminal as shown. Notes: � Ensure that the speaker cables are correctly connected. Improper connections may damage the system due to short-circuit. � Do not connect more than one speaker to any one pair of +/- speaker terminals.
"AUTO INSTALL - PRESS PLAY" may appear on the display panel when the AC power cord is plugged into the power outlet for the first time. Press � on the main unit to store all available � radio stations (page 3 - P3) or press � to exit (refer to �Tuner Operations�).
13
|
|
|
> |
|
