|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I liked the product. I would use their sevices again.
 ;
I Recently purchased yet another Service Manual from Owner-Manuals.com, this time for a Sony EVS700ES/UB Videocassette Recorder. The Manual was available for upload within two hours and is an Extremely Good copy, as some of this I was able to enlarge to get even better detail.
Once Again, Very happy with the result!
;
A good and useful manual. With these, We was abled to isolate and pin point the component that was causing the problem. The total time spent in troubleshooting is very much reduced.
;
The quality of the manual is top. The transfer worked perfect and fast.
No problems at all. Recommendable
;
Very good service for get any documentation. Fast and perfect quality.
2-2
2-2
Dismantling of the Front Display Board and Front Control Board
Dismantling of the Rear Portion
1) Remove 1 screw C as indicated to loosen the VCD GND Isolator Board (pos V1109). 2) Remove 1 screw C1 as indicated to loosen the Headphone Board (pos 1101-B). 3) Remove 5 screws D as indicated to loosen the Front Display Board (pos 1101-A). 4) Remove 9 screws E as indicated to loosen the Front Control Board (pos 1107-A). 5) Remove 1 screw F as indicated to loosen the IR-Eye Board (pos 1107-D). 6) Remove 3 screws N as indicated to loosen the VU Meter Board (pos 1107-C).
1) Remove 1 screw J and uncatch M1 as indicated to loosen the AF Board (pos 1102-A). 2) Remove 1 screw R as indicated to loosen the Video Out Cinch Board (pos V1102-B). 3) Remove 3 screws K and uncatch M2 as indicated to loosen the Tuner Board (pos 1103). 4) Remove 2 screws Q as indicated to loosen the Matrix Surround Socket Board (pos V1108) for set with Matrix Surround only. 5) Remove 4 screws L as indicated to loosen the Panel Rear (pos 256). Remove AF Board
Remove VCD GND Isolator Board, Headphone Board and Front Display Board
Remove VU Meter Board
Remove Front Control Board and IR-Eye Board
Repair Hints
Dismantling of the ETF Tape Module
1) The Knob Volume Gloss Black (pos 117) can be remove 1) Remove 6 screws G as indicated to loosen the ETF Tape Module (pos 1104). by inserting a strong string into the slot and pull it out in the direction as indicated. See picture 1. Picture 1
2) The Knob Jog Rotary (pos 140) can be remove by inserting a strong string into the slot and pull it out in the direction as indicated. See picture 2.
Picture 2
|
|
|
> |
|
