|
Who's Online
There currently are 5556 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
;
Great Job!!! clear and efficient as always!!
it is really nice to have peple that are doing such a good work!!!!!
CHAPTER 5 ERROR CODE
##106 (reception) procedure signal not received for 6 sec during reception Cause � The condition of the line is poor, and the procedure signal from the other party cannot be received properly. � The condition of the line is poor, and the other device cannot receive image signals properly. Remedy � Request the other party to raise the transmission level of the other device to ensure correct reception of the procedure signal. � Raise the transmission level of the modem using parameter 07 of #2 MENU so that the other device may receive signals properly. 1. Provide measures against echoes by referring to the descriptions under #1 SSSW SW03. 2. Lower the transmission level of the modem using parameter 07 of #2 MENU so as to prevent reception of echoes of transmitted CFR.
� An echo caused malfunction.
##107 (reception) fall-back not possible on transmitting device during reception Cause � The condition of the line is poor, and the signals from the other device cannot be received properly after starting 2400 bit/sec reception mode. Remedy 1. Request the other party to raise the transmission level of the other device so as to ensure correct reception of signals from the other device. 2. Adjust the NL equalizer using parameter 05 of #2 MENU so that the other device may receive TCF properly. 3. Relax the RTN transmission conditions using 02 through 04 of #3 NUMERIC Pram. so as to prevent transmission of RTN. 1. Provide measures against echoes by referring to the descriptions under #1 SSSW SW03. 2. Lower the transmission level of the modem using parameter 07 of #2 MENU.
� An echo caused malfunction.
##109 (transmission) non-DIS, -DTC, -FIT, -CFR, -CRP received after transmission of DCS during transmission, causing excess procedure signal re-transmission Cause � An error occurred in the procedure signal. Remedy � Make a recording of the exchange procedure sound on DAT and request the technology center for analysis.
5-8
COPYRIGHT © 1999 CANON INC. CANON SUPER G3 FAX BOARD-F1 REV.0 MAY 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
|
|
|
> |
|