|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This GRUNDIG UV5A Owner Manual is not only an instruction manual but a total functional circuit description of the Multimeter and includes circuit diagram at the end pages. It is very helpful for repairing and calibrating the instrument. It is written in two languages English and German for international support. It was very easy to repair my unit with this document. Regards, Regis Pauly, Electrical Engineer.
;
The owner's manual was evetything I thought it would be. I was able to print it out using both sides of the paper in quick order, saving me a search online for a used one.
 ;
Хорошее качество сканирования.
Мануал пришел часов эдак через 12. В целом доволен.
;
Fantastic quality and impressive delivery time. Based on this manual, I recommend this service without hesitation! Five Stars for certain.
;
Was happy to find the complete owners manual... It's all in there, just like the original...
Dishwasher installation
3. Installing the control panel.
The control panel and hardware is packaged separately from the dishwasher. It should be installed using the following procedure.
If a GDU decor kit is being used, (to convert an �i� dishwasher to a �U� version), the spacer bars g must first be removed and stored for possible use in the future (See the separate instructions for installing the GDU decor kit). If the GDU kit is not being used, skip the following step.
Install the number of spacer bars g required to align the lower edge of the control panel with the neighboring cabinet drawer line. Place the supplied seal b onto the ventilation grill c. Push the ventilation grill metal backing plate.
c into the
Place the control panel d over the backing plate and fasten it from the inside of the door e using the six screws provided. Align and press the program knobs onto their shafts f.
To remove the spacer bars from the control panel, place the panel on a table, printed side up, and gently push down on the spacer bars at a point near the bottom of the control panel. This will release the mounting bolts from their slots.
50
|
|
|
> |
|
