|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
;
excellent value & price! Includes everything you need to know about the NN-C777! I would buy this again.
;
Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
 ;
Generally speaking good copy; a few pages too hard contrast...
Good service and communication.
;
I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Dishwasher installation
Dishwasher installation The �i� model dishwasher is specially designed for installation under a continuous countertop. A panel can be custom made for installation on the front of the dishwasher, assuring a perfect match with the kitchen cabinetry. If a standard non-cabinet matching dishwasher installation is desired, the �i� model dishwasher can be converted into a �U� model through the addition of a GDU 60/65 decor set. The decor set comes supplied with separate installation instructions. To ensure stability, these dishwashers should only be installed under a continuous countertop which is securely fastened to the cabinet base units. Dimensions:
1. Install the steam deflector, (if applicable).
A stainless steel plate is supplied to protect the underside of the countertop against steam rising from the dishwasher when the door is opened. If the countertop is made of Corian®, granite, marble or other solid, waterproof material, the steam deflector should not be used.
Squeeze a bead of sealant from the supplied tube into the angle formed by the curved edge b of the coverplate. Align the plate c with the lower front edge of the countertop (see illustration) and use the supplied tacks to nail it into place. On countertops with wood or laminate edging, the tacks should be nailed through the rear holes of the plate.
1) with 2) with
35" 33 1/8"
(890 mm) machine height (840 mm) machine height
Range of adjustment is approximately 2" (5 cm).
43
|
|
|
> |
|
