|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I had been looking everywhere for a proper service manual for this VCR. Everywhere else that has this available for download has a very light version. This is the full service manual with all aspects that would interest anyone looking for the service manual for the AIWA HV-MX100 Worldwide VHS VCR. Great quality (as always). A winner hands down. Best Quality.
;
Top quality manual. Covers all aspects you'd expect in a top quality service manual for this Panasonic VHS VCR. The manual resolution is high. Another top quality manual from the only site worth downloading manuals from! If you're looking for a manual for the PV-9662 VHS VCR, this is the one you'll want to get!
;
complete part-lists and pcb layout, schematic diagram is good enlargable,
;
Excellent, fast delivery, excellent product. Good luck!
;
This manual is for the usa model only. But it is clear
, accurate and comprehensive, including board layouts and schematics.
I found it extremely useful for my mitsubishi dp-86da, but the same diagram would also work for the realistic lab5000 and hi fi 80. Thanks.
GC150AT/ATA 9. No power on
9.1 No power on (I)
Check output voltage +5V, +15V is right or not.
OK NG
It is not power board problem.
Check power switch is turn on or not.
NG OK
Turn switch on.
Check power cord ( P801), Signal cable (P302),P802, P803, CN102, CN103 is connected right or not. NG OK Connect it right.
Check C805 is about DC 140V-330V or not. NG OK Check F801, D801, P801 and repair them.
Check C807 is over 10V or not. NG OK Check R805, R803, I801 and repair them.
Check pin 6 of I801 have same pulse or not. NG OK Check peripheral components of I801 and repair them.
Check pin 1 of T802 have same pulse or not. NG OK Check Q803, R813, R814, D806 , R812 and repair them.
Check peak voltage of R811 triangle pulse is up to 1 volt or not. NG OK Check D804, R807 and repair them.
Check D809, D810, C816, C821, T802 have same short circuit, or the output +5V, +15V is over load. OK NG Repair them.
Check feedback circuit around I802, I803 and the other components and repair them.
Trouble Shooting
Page 11
|
|
|
> |
|
