|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good reproduction (copy) of original manual. Didn't have a parts list, but schematic was completely labeled with parts. Complete instructions on how to adjust mechanical functions of the 8-track deck. Well worth having and at a very reasonable cost.
;
It's a full manual. All the parts are in there. I haven't found the problem yett, but I am working on it; hope I can rebuild the part myself. To make it more secure and unbreakable this time. Because the part has failed several times before and costs a lot to let it be repaired.
Thanks so much for this rich illustrated and parted manual.
;
I downloaded the document. The manual was complete, well scanned and everything was legible. I could zoom in see what I needed to know. There's not much more that you can ask.
;
It was complete service manual with all needed service informations. Thanks.
 ;
El manual esta muy detallado, los numeros de partes y los esquemas de despiece son correctísimos y muy claros, tanto para los técnicos experimentados como para los novatos.
SECTION 3 TEST MODE
BASE UNIT
� MAIN Section � [Setting the Test Mode] 1. Power on with pressing the [INTERCOM] key for five seconds. 2. When the test mode is set, it beeps confirm tone and CHARGE LED turns on for 50 msec. Note: If setting the test mode with the status that [TONE] position is selected at [DIAL MODE] switch, the unit cold stars next time when the power is
turned on.
[Releasing the Test Mode] To release the test mode, perform as follows: � Turn the power off (disconnect the AC adapter plug). � Set the handset to charge on the base unit (except Test Mode 9). � Bell in. [Changing the Test Mode Step] 1. Set the [DIAL MODE] switch to the [PULSE] position. 2. Press the [INTERCOM] key. 3. A step is changed each time the key is pressed, and CHARGE LED turns on for 50 ms and it beeps confirm tone. [Changing the Channel] 1. Set the [DIAL MODE] switch to the [TONE] position. 2. Press the [INTERCOM] key. 3. A channel is changed each time the key is pressed, and CHARGE LED turns on for 50 ms and it beeps confirm tone.
Note: Channel will be back to initial channel (19CH), when the test mode step is changed.
� Channel Rotation
19CH
20CH
21CH
40CH
1CH
2CH
3CH
...
39CH
40CH
http://cxema.ru
� 16 �
|
|
|
> |
|
