|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good quality original datasheet!I like this amazing website!!!!!!
 ;
Excellent just what I needed to replace the electrolytic caps and make this old gem a beauty again. Was as scan of the original photocopied service manual.
;
It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
;
I want to give you a real heads-up for your desire to enable such people as I to acquire the information I need to maintain the older types of equipment such as this Akai HXA351W. You do a swell job with all the processes you have to perform so I can have a legible, thus usable
document which does not send me crazy trying to figure out the blurry text of a bad copy.
Very well done, Thomas.
;
This manual is very well presented and after printing out looks about as close to an original as I think you can get. The quality is second to none.
The content of the manual is comprehensive and I think it would be well suited to an audio repair professional which I'm not but I did find it very informative and helpful.
The cost of the manual is more than covered by the money I'll save when I change the keep memory battery now I have the relavant info.
Very pleased with my purchase and can recommend it wholeheartedly as I can other manuals I've downloaded from this site.
Regards
Limey Alex
GEX-P900DAB
3) Guard interval The time 25% more than the sampling time required for processing DAB signals by FFT is called "guard interval." For multipath within the time of guard interval, errors can be corrected in most cases, regardless of the D/U ratio. Mode 1 2048 points (1 ms): Number of samples required for FFT 512 points (250 µs): Guard interval
Delayed multipath wave S1 S2 Actual DAB signal S1 S2 Direct wave (OFDM wave)
Interference between different symbols (effect of delay) Time required for FFT (1 ms)
Guard interval (250 µs)
S1
S2 Received DAB signal
Time required for FFT for every symbol
The time of guard interval depends on modes. Different time of guide interval is used for transmitting frequency, receiving speed (vehicle speed), etc.
56
|
|
|
> |
|
