|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
 ;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
 ;
Super nice! Good to have a manual in digital format.
 ;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
 ;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
GFX2200HT GUITAR AMPLIFIER
The Rear Panel:
EFFECTS LOOP
SPEAKERS
LINE OUT
LINE IN
160 WATTS @ 4 OHMS 220 WATTS @ 2 OHMS 2 OHM MIN. LOAD
22
23
24
25
22. EFFECTS LOOP LINE OUT: When using an external effects processor, connect this jack to the input of the effect by means of a shielded signal cable. This jack also doubles as a source for a post-EQ, preamp signal to send your signal to a mixing board, recorder, powered monitor or external amplifier. 23. EFFECTS LOOP LINE IN: When using an external effects processor, connect this jack to the output of the effect by means of a shielded signal cable. This jack also doubles as a direct connection to the power amp, bypassing the input and preamp stages. This is useful for �slaving� a pair of amplifiers together.
24. SPEAKERS: Use these jacks to connect the amplifier to your speaker cabinet(s) using speaker cables with mono 1/4� plugs. These jacks are wired in parallel. Make sure that the combined impedance of your speakers is equal to or greater than 2 ohms! Use the chart below to help determine parallel loads. If in doubt, ask your dealer.
CAB IMP 4 ohms 8 ohms 8 ohms 16 ohms 16 ohms 16 ohms # CABS TOTAL IMP 2 2 4 2 4 8 2 ohms 4 ohms 2 ohms 8 ohms 4 ohms 2 ohms
25. POWER CORD: This grounded power cord is to be plugged into a grounded power outlet, wired to current electrical codes and compatible with the voltage, power, and frequency requirements stated on the rear panel. Don not attempt to defeat the safety ground connection.
5
|
|
 |
> |
|