|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
 ;
Minden rendben, de két megjegyzés, az ábrák nehezen kivehetők és a fizetés után 24 órát kell várni a letöltésre.
;
Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
;
This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
;
Fast and courteous service. Product delivered as described. Thank you.
Chapter 4 Other Functions
Reset to Default Factory Settings (Factory Reset)
The procedure for restoring the GI-20�s internal settings to the state they were in when the unit left the factory is called a �Factory Reset.� This procedure allows you to return the patch parameters for Patches 01�50, pickup sensitivity settings, MIDI transmission, and other system parameters to their original factory values. Here, you can set the GUITAR/BASS switch to select patch content that is optimized for the use of either a guitar or bass. * With the factory settings, this is set to patches that are optimized for the guitar.
Screw (M4 x 8)
Installing the Rack Mount Adaptor
When installing on the rack-mount adaptor (RAD-50; optional), use the screw (M4 x 8) included with the rackmount adaptor.
fig.04-03
The Factory Reset operation undoes any settings you have changed and discards any edits you have made to its patches. If you have settings or patches you wish to preserve, use the Bulk Dump operation (p. 29) to save them, before performing the Factory Reset operation. 1. Turn off the power to the GI-20. 2. Set GUITAR/BASS to match the instrument you are using (guitar or bass). 3. Hold down [TUNER (STRING SEL)] and turn on the power. �in� appears in the display.
fig.04-01
Attaching the Rubber Feet
If you are not going to be using a rack mount adaptor, attach the rubber feet as shown.
fig.04-04
Affix the supplied rubber feet onto the bottom of the unit
Flash
* To cancel the procedure, turn off the power to the GI-20. 4. Press [WRITE]. �Wr� appears in the display and the dot in the display flashes, and Factory Reset is carried out.
fig.04-02
Flash
When Factory Reset is completed, �oF� flashes in the display.
Never turn off the power while Factory Reset is in progress. Doing so may damage the unit. 5. Turn off the power to the GI-20.
34
|
|
|
> |
|
