|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good scanning quality. All schematics are very legible. Worth every cent !
;
Excellent quality, very quick download turnaround, will definately use again.
 ;
This is a awesome quality scan of the original Service Manual for Technics 8099.
Contains the circuit diagram, PCB layout, adjust/tune instructions as well.
Since this is my first buy here, i'm really glad! This site do works as intended/described, it's definitely not scam!
Мои рекомендации! Все мануалы настоящие!
;
Good Quality of the File.
You get the normal manual is incudet.
;
Very nice and real Service Manual, I didn't thought it actually exist in the real world at all.
GM-8886ZT ,8886ZT-91
ASL SECTION
Preset conditions 1. Set VR601 and VR602 around the center of the adjustable range. 2. Ground pins 3 and 16 of IC601. Step Input Output No. (MIC) (Pin 22) Adj.point 1 By using an oscillator, apply a sine Observe the output at VR602 wave of 7Hz/3.6mV to the MIC Pin 22 on a DC V meter terminal (+) via a 600-ohm resistor. (pointer-type). 2 By using an oscillator, apply a sine Observe the output at VR601 wave of 7Hz/64mV to the MIC Pin 22 on a digital terminal (+) via a 600-ohm resistor. multimeter. 3 Repeat Steps 1 and 2 until doth adjustments satisfy the specifications. 4 By using the jig(CAN-906,CAN-912), Observe the output at VR602 apply a sine wave of 7Hz/100dB-SPL Pin 22 on a digital directly to the MIC. multimeter. 5 End To connect the Amp unit and the DSP unit, use Jig GGD1153.
Adjustment Spec. Conditions 1.3±0.3V Pin 16:Ground Pin 3:Open Wait for 20 seconds. 4.6±0.1V Pin 16:Ground Pin 3:Ground
3.6±0.1V
Pin 16:Ground Pin 3:Open
TOP VIEW
BOTTOM VIEW
Oscillator
600�
DSP UNIT
VR602
DSP UNIT
MIC
22pin VR601
DC V meter Digital multi meter
13.2V
DC Regulated Power Supply
13.2V
MUTE
SGND
L+
R+
BU
FL+
FR+
RL+
RR+
ACC
BUS+ BUS-
L-
R-
GND
TLMT
GND
FL-
FR-
RL-
WF-
WF+
RR-
CN903
CN901
CN903
CN902
CN901
AMP UNIT
24
|
|
|
> |
|
