|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellant, finally this is want I need and searching for The service manual is fantastic and thank you to owner-manuals.com and its service. Price is reasonable. It's a bit slow on my end in downloading but manage to receive the whole manual without a break. once again, thanks.
;
Very good scanning quality. All schematics are very legible. Worth every cent !
;
Excellent quality, very quick download turnaround, will definately use again.
 ;
This is a awesome quality scan of the original Service Manual for Technics 8099.
Contains the circuit diagram, PCB layout, adjust/tune instructions as well.
Since this is my first buy here, i'm really glad! This site do works as intended/described, it's definitely not scam!
Мои рекомендации! Все мануалы настоящие!
;
Good Quality of the File.
You get the normal manual is incudet.
GM-X354
18
up, turn these controls clockwise. If standard tip screwdriver. (GM-X354/X1R/EW,ES) same position.
Setting the Unit
Gain Control Power Indicator
Adjusting gain controls A and B will The power indicator lights when the help match output of the car stereo power is switched on. to the Pioneer amplifier. Normally, set gain controls to the �NORMAL� position. If the output is low, even when volume of the car stereo is turned
BFC (Beat Frequency Control) Switch
there is distortion when the volume of If you hear a beat while listening to an the car stereo is turned up, turn these MW/LW broadcast with your car stereo, controls counter-clockwise. change the BFC switch using a small
� If you only use one input plug, set the gain
controls for speaker outputs A and B to the
� When using with an RCA equipped car
stereo (standard output of 500 mV), set to the NORMAL position. When using with an RCA equipped Pioneer car stereo with max. output of 4 V or more, adjust level to match the car stereo output level.
� If you hear too much noise when using the
speaker input terminals, turn the gain control counter-clockwise.
LPF (Low-Pass Filter)/HPF (High-Pass Filter) Select Switch
to speaker output connector and the car stereo system: LPF/HPF Select Audio frequency range Speaker Remarks Switch to be output Type
LPF (Left) Very Low Frequency range Subwoofer Connect a subwoofer. OFF (Center) Full range HPF (Right) Low Frequency Full range Use if you want to cut the High Frequency very low frequency range because it is not necessary for the speakers you are using.
Input Select Switch Set LPF/HPF select switch as follows according to the type of speaker that is connected
For two-channel input, slide this switch to the left. For four-channel input, slide this switch to the right.
|
|
|
> |
|
