|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
 ;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
;
Rapid, clear well done as all the scheme I downloaded from this site. Great job very functional and very useful
Power Indicator Gain Control
8.2 OPERATIONS
If sound level is too low, even The power indicator lights when the volume of the car stereo used along power is switched on. with this power amplifier is turned up, turn gain control on back of the power amplifier clockwise. If the sound distorts when the volume is turned up, turn the gain control counter-clockwise.
� Set the gain control to �NORMAL� when
this amplifier is connected to a Pioneer car stereo with RCA output jacks. If the sound level is too low or distorts, adjust the gain control.
GM-X622,GM-X522
� If you hear much noise when using the
speaker input terminals, turn the gain control clockwise. Cut Off Frequency Control
� Adjust gain control to the �MIN� side
of �NORMAL� when this amplifier If the LPF/HPF select switch is set to connected to Pioneer car stereo (High LPF or HPF, you can select a cut off voltage output type). frequency from 50 to 120 Hz.
LPF (Low-Pass Filter)/HPF (High-Pass Filter) Select Switch Bass Boost Level Control
Set LPF/HPF select switch as follows according to the type of Bass level control can boost the that is connected to speaker output connector and the car level around the frequency selected by stereo system: the bass boost frequency control from 0 LPF/HPF Select Audio frequency range Speaker Remarks Switch to be output Type
LPF (left) * � 50 to 120 Hz Sub-woofer Connect a sub-woofer. OFF (center) Full range
to 12 dB.
Bass Boost Frequency Control
You can select a bass boost frequency HPF (right) * 50 120 Hz � Full range Use if you want to cut the from 40 to 120 Hz with the bass boost very-low-frequency range* control. because it is not necessary
� Level Control and Bass Boost for the speakers you are Frequency Control can be adjusted only using. when the LPF/HPF select switch is set to a position other than HPF.
* See the �Cut Off Frequency Control� section.
|
|
|
> |
|
