|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent just what I needed to replace the electrolytic caps and make this old gem a beauty again. Was as scan of the original photocopied service manual.
;
It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
 ;
I want to give you a real heads-up for your desire to enable such people as I to acquire the information I need to maintain the older types of equipment such as this Akai HXA351W. You do a swell job with all the processes you have to perform so I can have a legible, thus usable
document which does not send me crazy trying to figure out the blurry text of a bad copy.
Very well done, Thomas.
;
This manual is very well presented and after printing out looks about as close to an original as I think you can get. The quality is second to none.
The content of the manual is comprehensive and I think it would be well suited to an audio repair professional which I'm not but I did find it very informative and helpful.
The cost of the manual is more than covered by the money I'll save when I change the keep memory battery now I have the relavant info.
Very pleased with my purchase and can recommend it wholeheartedly as I can other manuals I've downloaded from this site.
Regards
Limey Alex
;
Complete manual including mechanical part in good pdf quality. Shaded greys of the pcb due to pdf not perfect but usable.
GM-X922, GM-X1022
20
- SETTING THE UNIT
Gain Cut Off Frequency Control Power Indicator
sound level too low, even If LPF select switch is set to LPF, The power indicator lights when the volume of the car stereo used along you can select a cut off frequency from power is switched on. with this power amplifier is turned up, 50 to 120Hz. turn gain control on back of the power amplifier clockwise. If the sound distorts when the volume is turned up, turn the gain control counter-clockwise.
� Set the gain control to �NORMAL� when
this amplifier is connected to a Pioneer car stereo with RCA output jacks. If the sound level is too low or distorts, adjust the gain control.
� Adjust gain control to the �MIN� side
of �NORMAL� when this amplifier is connected to a Pioneer car stereo (High voltage output type).
8. OPERATIONS AND SPECIFICATIONS
Bass Boost Level Control
Bass level control can boost the level around the frequency selected by the bass boost frequency control from 0 to 12 dB.
LPF (Low-Pass Filter) Select Switch
Set LPF select switch as follows according to the type of speaker that is connected to speaker output connector and the car stereo system:
LPF Select Audio frequency range Speaker Remarks
Bass Boost Frequency Switch to be output Type Control(GM-X1022) ON (right) * � 50 to 120 Hz Sub-woofer Connect a sub-woofer.
OFF (left) Full range * See the �Cut Off Frequency Control� section. control.
You can select a bass boost frequency from 40 to 120 Hz with the bass boost
Fig. 10
|
|
|
> |
|
