|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Found this to be the manual included with the original packinging, was helpfull but did not give any detailed repair instructions.
 ;
Complete service manual, was very helpful in repairing this tapedeck.Thanks.
;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
;
Good,readable manual. I found other manuals that were not readable when it came to part ID, but the one downloaded from owner-manual.com was better than expected. I will do buisness with owner-manual.com again.
;
Service Manual that I received was very helpful to me. Thank you.
GM-X1024,GM-X924
7.2 DISASSEMBLY
Panel Unit
A A B B B A A A A A A B B
- Removing the Case and the Panel Unit
1. Remove eight screws A, seven screws B and two screws C. 2. Remove Case and Panel Units.
C B
Case
B C
Panel Unit
Fig. 13
D
B LPF/HPF PCB A LPF/HPF PCB
- Removing the Heat Sink
Some silicone glue has been applied between the Heat Sink and the Heat Sink(Sub). therefore, to remove the Amp Unit from the Heat Sink. 1. Remove two screws D.
D
F F F F
F
Heat Sink(Sub)
E E
F
F F E
2. Remove A LPF/HPF PCB and B LPF/HPF PCB. 3. Remove four screws E and eight screws F. 4. Use 2 pcs. of screw E and insert them into the two holes marked with an arrow. 5. Alternately tighten them little by little until the Heat Sink(Sub) separates from the Heat Sink.
E
Heat Sink(Sub) Amp Unit Heat Sink
Fig. 14
27
|
|
|
> |
|
