|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good scan quality, only PC Board scan not enough contrast.
;
First of all I must say that I received the manual in just a few minutes after placing the order. The copy is well done and very readable. I will buy others soon... Thanks, Meyer
 ;
Good service manual. I gat all I want. Copy is good, but could be better. All clear and useful. I sincerely recommend.
;
The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.
;
Welcome. The scheme is clearly helped me to repair. Worth to download it.
GR-209
7. GENERAL INFORMATION
7.1 IC
� The information shown in the list is basic information and may not correspond exactly to that shown in the schematic diagrams.
M5229P (MAIN BOARD ASSY : IC2, IC3)
� Graphic Equalizer
�Pin Arrangement
IN 1 1 NF 1 2 IN 2 3 NF 2 4 IN 3 5 NF 3 6 IN 4 7 NF 4 8 IN 5 9 NF 5 10 20 �Vcc 19 GND 18 +Vcc 17 OUTPUT 16 INVERTING INPUT 15 NON-INVERTING INPUT 14 NF 7 13 IN 7 12 NF 6 11 IN 6
�Block Diagram
�Vcc GND +Vcc OUTPUT
NONINVERTING INVERTING INPUT INPUT
NF 7
IN 7
NF 6
IN 6
20
19
18
17
16
15
14
560
13
12
560
11
10k
10k
47k
47k
47k
47k
47k
47k
47k
47k
560
560
560
560
560
1
IN 1
2
NF 1
3
IN 2
4
NF 2
5
IN 3
6
NF 3
7
IN 4
8
NF 4
9
IN 5
10
NF 5
�Pin Function
No. 1 2 3 4 5 6 7 8 9 Pin Name IN 1 NF 1 IN 2 NF 2 IN 3 NF 3 IN 4 NF 4 IN 5 Compose the bandpass filter by connecting a capacitor with IN terminals and NF terminals located next to each other, and the gain can be set up by connecting a variable resistor (slide volume). Function No. 11 12 13 14 15 16 17 18 19 20 Pin Name IN 6 NF 6 IN 7 NF 7
Non-inverting input Inverting input
Function Compose the bandpass filter by connecting a capacitor with IN terminals and NF terminals located next to each other, and the gain can be set up by connecting a variable resistor (slide volume). Non-inverting input pin for output OP amp. Inverting input pin for output OP amp. Output pin for output OP amp. Positive power supply pin Ground pin Negative power supply pin
OUTPUT +Vcc GND � Vcc
10 NF 5
11
|
|
|
> |
|
