|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good copy of Manual, clear and easy to print off, arrived very promptly and reasonably priced.
Thanks, I will use you again.
;
Zeer duidelijke afdrukken op A4-formaat , zeer uitgebreide handleiding . Pluspunt ,zeer snelle
respons van jullie , binnen de 24h . Top !!!
;
I AM HIGHLY IMPRESSED BY THE EASE OF USE OF THIS DOWNLOAD SERVICE. INSTRUCTIONS ARE CLEAR AND SIMPLE TO FOLLOW....EVEN BY TECHNOPHOBES SUCH AS MYSELF. THE EMAILS POINT YOU IN THE RIGHT DIRECTION...ITS SO EASY PEASY. THE DOWNLOAD CHOICE OF USER MANUALS IS EXTENSIVE AND I COULD NOT FIND A CHEAPER OR MORE EFFICIENT SERVICE ON THE INTERNET. I COULD NOT HAVE MADE A BETTER CHOICE OF INFORMATION PROVIDER. SHOULD I EVER NEED ANOTHER USER MANUAL, THEN THIS IS THE FIRST CHOICE SITE. COULD NOT BE BETTER PLEASED!!!!!!!...MANY THANXES FROM JIM BURNS
;
I was impressed with the quality of service (frequent e-mails to let you know the status of your order), and the speed at which the download became available. The manual was a life saver and was not easy to track down. Thank you for such an excellent service.
;
the manual was just what i wanted it had all the revelent information required to operate the hifi .Iwould use any manual i downloaded for any item which needs a manual
33
COUNTER R/M
Insert Editing
You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.
NOTE:
You need the optional RM-V20U remote control unit to perform the following procedure.
SELECT MODE
1 2 3
POWER
M-0:12:34
Set the power switch to PLAY.
FIND EDIT-OUT POINT RESET COUNTER
Locate the point and press PAUSE on the camcorder or the remote control. Press and hold COUNTER R/M for more than 2 seconds to reset the tape counter, then press for less than 1 second and make sure �M� appears in the viewfinder.
FIND EDIT-IN POINT
Tape Counter Insert editing indicator Viewfinder
4 5 6
Press REW to go a little beyond the beginning of the scene you want to replace, press PLAY to view the recorded tape, and press PAUSE at exactly at the point where the new scene should start.
ENGAGE INSERT EDITING MODE
Press and hold INSERT, and press PAUSE. The Insert mode is engaged, and the scene the camcorder is aimed at appears on the screen.
BEGIN INSERT EDITING
Press Recording Start/Stop. When the counter reaches �0:00:00�, editing stops automatically and the camcorder enters the playback mode.
NOTES:
REW PLAY PAUSE AUDIO DUB INSERT
RM-V20U (optional)
� Insert Editing may not work correctly if a blank segment exists in the recorded tape, or if the recording speed was changed. � The tape may stop slightly before or after the designated end point, and noise bars may appear. Neither indicates a defect in the unit. � To edit onto a tape with the recording safety tab removed, cover the hole with adhesive tape. � Only video signal is recorded in the Insert Editing mode. When the sound is to be recorded, press AUDIO DUB and PAUSE simultaneously after Step 5. When INSERT and PAUSE are pressed simultaneously again, the unit re-enters the Video-signal-only Recording mode. � If the camcorder�s mike is too close to the TV, or if the TV�s volume is too high, whistling or howling may occur.
|
|
|
> |
|
