|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Fast service, document is OK. Thanks! Searched for it long time.
 ;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
;
The product manual I received was exactly what I was looking for, delivered painlessly at a very fair price. I can't ask for any more than that.
;
Very well done!!!!! congratulations. It was a bit longer than usual the wiating time even if it was on time (in 24 hours).
46
EN
TROUBLESHOOTING
POSSIBLE CAUSE(S)
� The battery pack has not been attached correctly ( pg. 4). � The battery pack is not charged ( pg. 4). � The power supply has not been correctly connected ( pg. 5). � The battery pack has completely discharged. � Remove the cassette and disconnect the power source, then after a few minutes, try turning the power back on. If it still doesn�t come on, consult your nearest JVC dealer.
SYMPTOM POWER
No power is supplied.
The power suddenly goes off and doesn�t come back on by itself.
RECORDING
Recording cannot be performed. � Make sure the Erase Protection tab is in the position that allows recording. If not, slide the tab. Some cassettes have removable tabs. If the tab has been removed, cover the hole with adhesive tape. � The camcorder Power Switch has not been set to �CAMERA� ( pg. 12).
Recording does not start.
PLAYBACK
The tape is running, but there�s no playback picture. � The TV has not been set to its VIDEO mode. � If A/V connection is used, the TV�s VIDEO/TV Switch has not been set to VIDEO. � The RF unit has not been set to the correct channel. � The video heads are dirty or worn out. Consult your nearest JVC dealer for head cleaning or replacement. � This is normal.
Playback picture is blurred or interrupted. The counter indication is blurred during Still playback.
TAPE TRANSPORT
The tape stops during fast-forward or rewind. Rewinding or fast-forwarding cannot be performed. � The Counter Memory Function has been activated ( pg. 34). � The tape is already fully wound on one reel or the other.
|
|
|
> |
|
