|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
What can i say but i would have been lost without your support.
Thank You!
;
Très satisfait ! envoi rapide, Grand catalogue disponible. Many thanks !
;
Delivery came quite promptly and in a very readable format. Thank you.
;
I found my Clarion VRX8370R in the Camper I bought and I wasn't able for month to understand it.
The Owner Manual was perfect and just what I was searching for.
Thank you.
Leonardo
;
Very good copy of Manual, clear and easy to print off, arrived very promptly and reasonably priced.
Thanks, I will use you again.
48
EN
USING REMOTE CONTROL UNIT (cont.)
Insert Editing
You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged. FF STOP
COUNTER R/M PLAY/PAUSE REW
NOTE:
Use the RM-V705U or RM-V700U remote control unit to perform this procedure.
SELECT MODE
1 2
Power Switch
Set the Power Switch to �PLAY�.
FIND EDIT-OUT POINT RESET COUNTER
Play back the tape, locate the point and press PAUSE on the camcorder or the remote control. Press and hold COUNTER R/M for more than 1 second to reset the tape counter, then press again for less than 1 second and make sure �M� appears.
3 4 5 6 7
Insert editing indicator
FIND EDIT-IN POINT
Press REW to go a little beyond the beginning of the scene you want to replace, press PLAY to view the recorded tape, and press PAUSE exactly at the point where the new scene should start.
M�0:12:34
Tape Counter
ENGAGE INSERT EDITING MODE
Viewfinder Press and hold INSERT, and without releasing INSERT, press and release PAUSE. The Insert mode is engaged. When the scene the camcorder is aimed at appears on the screen, go to the next step.
BEGIN INSERT EDITING
Press START/STOP. When the counter reaches �0:00:00�, editing stops automatically and the camcorder enters the Insert-Pause mode.
END INSERT EDITING
Press STOP.
START/STOP REW PLAY PAUSE REW INSERT RM-V700U (optional) OR RM-V705U (provided)
NOTES:
� After step 5, Retake ( pg. 19) can be performed. � The tape may stop slightly before or after the designated end point, and noise bars may appear. Neither indicates a defect in the unit. � Only video signal is recorded in the Insert Editing mode.
|
|
|
> |
|
