|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
;
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
;
Manual was complete and available promptly, since I had lost my original manual. Very good response.
;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
44
EN
USING REMOTE CONTROL UNIT (cont.)
COUNTER R/M
Insert Editing
You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.
NOTE:
Use the RM-V705U or RM-V700U remote control unit to perform this procedure.
SELECT MODE
1 2
POWER
Set the Power switch to �PLAY�.
FIND EDIT-OUT POINT RESET COUNTER
Play back the tape, locate the point and press PAUSE on the camcorder or the remote control. Press and hold COUNTER R/M for more than 2 seconds to reset the tape counter, then press for less than 1 second and make sure �M� appears in the LCD monitor or the viewfinder.
3
Tape Counter Insert editing indicator
M-1:23:45
FIND EDIT-IN POINT
4 5 6 7
LCD monitor or viewfinder
Press REW to go a little beyond the beginning of the scene you want to replace, press PLAY to view the recorded tape, and press PAUSE at exactly at the point where the new scene should start.
ENGAGE INSERT EDITING MODE
Press and hold INSERT, and without releasing INSERT, press and release PAUSE. The Insert mode is engaged. When the scene the camcorder is aimed at appears on the screen, go to the next step.
BEGIN INSERT EDITING
Press START/STOP. When the counter reaches �0:00:00�, editing stops automatically and the camcorder enters the Insert-Pause mode.
END INSERT EDITING
Press STOP. START/STOP REW PLAY PAUSE REW INSERT RM-V700U (optional) OR RM-V705U (provided)
NOTES:
� When Insert Editing is performed with the LCD monitor fully opened, the original audio will be heard from the speaker. � After step 5, Retake ( pg. 18) can be performed. � The tape may stop slightly before or after the designated end point, and noise bars may appear. Neither indicates a defect in the unit. � Only video signal is recorded in the Insert Editing mode.
|
|
|
> |
|
