|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thanks to Owner-Manuals.com! This manual was exactly what I needed. As Amana was purchased by Maytag and later by Whirlpool, there was no way to receive it from their websites. I was lucky to find this resource.
 ;
Great to be able to set channels again, on an old but stoll fine working TV
;
Good quality instructions manual. Very useful to me. Quick and excellent service from Owner-Manuals... Thanks !!!
;
Sono molto soddisfatto e, quando mi necessiterà, mi avvarrò nuovamente di questo servizio!
;
A comprehensive Operating and Service Manual. All schematics are complete and easy to read. The PCB drawings and complete parts list are very helpful. I would definitely recommend this manual.
12 EN
GETTING STARTED
How To Attach The Lens Cap
To protect the lens, attach the provided lens cap to the camcorder as shown in the illustration.
Power
This camcorder�s 2-way power supply system lets you choose the most appropriate source of power. Do not use provided power supply units with other equipment.
NOTE:
To confirm the lens cap is on correctly make sure the cap is flush to the camcorder.
Charging The Battery Pack
Battery pack mount
Battery pack
PUSH BATT.
Place here during shooting.
How To Attach The Shoulder Strap
Follow the illustration.
Arrow
POWER/ CHARGE lamp
1 Thread the strap through the eyelet. 2 Fold it back and thread it through the strap
guide and the buckle.
� To adjust the length of the strap, loosen and then tighten the strap in the buckle.
To DC connector
To AC outlet Power switch
3 Slide the strap guide fully towards the eyelet.
Buckle Strap guide AC Adapter (ex. AP-V17E)
2 2
1 Set the Power Switch to �OFF�. 2 With the arrow on the battery pack pointing 3 Slide down the battery pack until it locks in
place b.
downward, push the battery pack slightly against the battery pack mount a.
4 Connect the AC Adapter to the camcorder. 5 Connect the Power Cord to the AC Adapter.
(AP-V14E only)
1
Eyelet
3
6 Plug the AC Adapter into an AC outlet. The
POWER/CHARGE lamp on the camcorder blinks to indicate charging has started. 7 When the POWER/CHARGE lamp goes out, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.
|
|
|
> |
|
