|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great site, I always find all the manuals I need and i can't find anywhere else. PDF for the Sony PCM 3348 is complete and scan is good quality. Thank you!
;
It was a complete manual as stated. Very good source for older product manuals. Thanks
;
Scan quality is very good. Price is very reasonable. If you're looking to purchase a copy of this manual, this is the one to get.
 ;
Perfect for my use.Could have better pictures,but otherwise perfect ;)
;
This is one of four manuals I have downloaded recently.
Purchase was very straight forward and the authorising email arrived in about 4 hours.
The quality of the scan is good. Print is clear and square to the page edges.
12 EN
GETTING STARTED
How To Attach The Lens Cap
To protect the lens, attach the provided lens cap to the camcorder as shown in the illustration.
Power
This camcorder�s 2-way power supply system lets you choose the most appropriate source of power. Do not use provided power supply units with other equipment.
NOTE:
To confirm the lens cap is on correctly make sure the cap is flush to the camcorder.
Charging The Battery Pack
Battery pack mount
Battery pack
PUSH BATT.
Place here during shooting.
How To Attach The Shoulder Strap
Follow the illustration.
Arrow
POWER/ CHARGE lamp
1 Thread the strap through the eyelet. 2 Fold it back and thread it through the strap
guide and the buckle.
� To adjust the length of the strap, loosen and then tighten the strap in the buckle.
To DC connector
To AC outlet Power switch
3 Slide the strap guide fully towards the eyelet.
Buckle Strap guide AC Adapter (ex. AP-V17E)
2 2
1 Set the Power Switch to �OFF�. 2 With the arrow on the battery pack pointing 3 Slide down the battery pack until it locks in
place b.
downward, push the battery pack slightly against the battery pack mount a.
4 Connect the AC Adapter to the camcorder. 5 Connect the Power Cord to the AC Adapter.
(AP-V14E only)
1
Eyelet
3
6 Plug the AC Adapter into an AC outlet. The
POWER/CHARGE lamp on the camcorder blinks to indicate charging has started. 7 When the POWER/CHARGE lamp goes out, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.
|
|
|
> |
|
