Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
Text excerpt from page 60 (click to view)
60 EN
TROUBLESHOOTING
? Appears when playing back a file that is not compatible with DCF or a file with a size that is not compatible with this camcorder. COPYING FAILED � Appears if dubbing of copyguarded signals is attempted while this camcorder is being used as a recorder. � Appears in the following cases when dubbing from a tape to a memory card*:
� when no memory card is loaded. � when the memory card�s memory is full. � when the memory card is not formatted. � when a write-protected SD Memory Card is loaded. ( pg. 33)
LENS CAP Appears for 5 seconds after power is turned on if the lens cap is attached or when it is dark. A. DUB ERROR! Appears if Audio Dubbing is attempted on a blank portion of a tape. ( pg. 55)
A. DUB ERROR! <CANNOT DUB ON A LP RECORDED TAPE> <CANNOT DUB ON A 16BIT RECORDING> <CHECK TAPE�S ERASE PROTECTION TAB> � Appears if Audio Dubbing is attempted on a tape recorded in the LP mode. ( pg. 55) � Appears if Audio Dubbing is attempted on a tape recorded in 16-BIT audio. ( pg. 55) � Appears if A. DUB (D) on the remote control is pressed when the erase protection tab is set to �SAVE�. ( pg. 55) INSERT ERROR! Appears if Insert Editing is attempted on a blank portion of a tape. ( pg. 56) INSERT ERROR! <CANNOT EDIT ON A BLANK PORTION> <CANNOT EDIT ON A LP RECORDED TAPE> <CHECK TAPE�S ERASE PROTECTION TAB> � Appears if Insert Editing is attempted on a blank portion of a tape. � Appears if Insert Editing is attempted on a tape recorded in the LP mode. ( pg. 56) � Appears if INSERT (I) on the remote control is pressed when the erase protection tab is set to �SAVE�. ( pg. 56) MEMORY IS FULL* Appears when the memory card�s memory is full and shooting is not possible. HDV Appears when pictures recorded in the HDV format are detected. The pictures in the HDV format cannot be played back with this camcorder.
MEMORY CARD!* Appears if there is no memory card loaded when you attempt to record on a memory card or access data on a memory card. PLEASE FORMAT* Appears when there is a problem with a memory card and its memory is corrupt, or it has not been initialised. Initialise the memory card. ( pg. 36) NO IMAGES STORED* Appears if there are no image files stored in the memory card when you attempt memory card playback. NO E-MAIL CLIP STORED* Appears if there are no video clip files stored in the memory card when you attempt memory card playback. CARD ERROR!* Appears when the camcorder does not recognise the loaded memory card. Remove the memory card once and insert it again. Repeat these procedures until no indication appears. If the indication still appears, the memory card is corrupted.
