|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a high quality manual with clear schematic and components layout diagrams ; with service procedure included.
 ;
This service manual for the Kenwood KT-990D was reproduced really well ,is very legible and manual is complete.Combined with the low price paid,in the future,I will be checking Owner-Manuals.com any time I need a manual.
;
When I purchased this manual I had my doubts regarding the quality as the price was so reasonable as compared to other outlets.
The manual itself is of high standard the print is very clear as are the diagrams. Obviously with the diagrams one has to zoom in otherwise it is to small to be able to read.
Overall I am very pleased with the company who delivered as they said and with the manual they supplied.
I occasionally require a manual and now having registered with this company I shall order from them in the future.
;
I was at first dubious about payiong for downloaded manuals but having done so, I was extremely impressed with quality of the two manual I ordered, well worth the small price I paid.
I would highly recommend these to my friends.
;
reasonable price for the schematic - the service is perfect, all as expected and pointed by instructions - good scan of the original plans - thank you!
2.6.2 Adjustment of the Tension Arm and Pad Arm Assemblies Use Fig. 2-6-2 as the reference unless otherwise specified. 1. Set the PLAY mode. Se Fig. 2-3-8. 2. Loosen the screw A . 3. With the take-up side at the bottom, align the extreme end of the Tension Arm Assembly with the crossed grooves on the screw B that retains the Loading Motor Assembly and then tighten the screw A . The tightening torque should be 0.069 N�m (0.7 kgf�cm). 4. Check the operation. Repeat unloading and loading several times and make sure that the Tension Arm Assembly is located within the normal range. Note : With the above checking method, a Torque Meter is not used. When a Torque meter is used, the following are the reference values: Back Tension : 2.0 to 6.0 g�cm Play Torque : 8.3 to 12.5 g�cm
SCREW B TENSIOM ARM ASSY
2, 3 SCREW A
Fig. 2-6-2
2.6.3 Adjustment of the Slide Lever 2 Use Fig. 2-6-3 as the reference unless otherwise specified. 1. Set the C IN mode. See Fig. 2-3-4. 2. Loosen the screw A . 3. Set the Main Deck and Slide Deck Assemblies apart so that they do not rattle, then tighten the screw A by screwing it fully toward the Drum Assembly. The tightening torque should be 0.069 N�m (0.7 kgf�cm). 4. Check the operation. Repeat unloading and loading several times and make sure that these operations can be performed smoothly without producing rattles.
3
2, 3 SCREW A
3
Fig. 2-6-3
2-16
|
|
|
> |
|
