|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This Manual (as downloaded) is both informative and comprehensive and has proved to be extremely useful. thoroughly recommended.
;
everything is ok, thank you very much! Product is good, no problems with download!
;
Great site, I always find all the manuals I need and i can't find anywhere else. PDF for the Sony PCM 3348 is complete and scan is good quality. Thank you!
;
It was a complete manual as stated. Very good source for older product manuals. Thanks
;
Scan quality is very good. Price is very reasonable. If you're looking to purchase a copy of this manual, this is the one to get.
62
EN
TROUBLESHOOTING (cont.)
POSSIBLE CAUSES
37. �The temperature of the battery is extremely high/low. �Charging is difficult in places subject to extremely high/low temperatures. 38. �This occurs when recording in the LP mode is not available. After the indicator blinks, the recording mode
switches to �SP� and recording goes on.
SYMPTOM
37. The charge indicator on the AC Power Adapter/ Charger does not light.
CORRECTIVE ACTION
37. � To protect the battery, it is recommended to charge it in places with a temperature of 10°C to 35°C ( pg. 69). 38.
����
38. The recording mode indicator �LP� blinks.
39. Picture does not appear on the LCD monitor.
39. �The lens cover is closed. �The LCD monitor is not open at an angle of over 60 degrees. �The LCD monitor�s brightness setting is too dark.
39. � Open the lens cover ( pg. 14). � Open the LCD monitor to an angle of over 60 degrees. � Adjust the brightness of the LCD monitor ( pg. 17). � If the monitor is tilted upward to 180 degrees, open the monitor fully ( pg. 17). 40. � Open the lens cover ( pg. 14). � Close the LCD monitor. � Open the LCD monitor and tilt it upward 180 degrees so that it faces forward ( pg. 17). 41. � By recording with Picture Stabilizer activated ( pg. 18) this can be avoided. 42. � Replace with a charged battery pack ( pg. 6). 43. � Use a new, or infrequently used, tape for Audio Dubbing ( pg. 56, 57).
40. Picture does not appear in the viewfinder.
40. �The lens cover is closed. �The LCD monitor is open. �If the LCD monitor is not facing forward towards the subject, Interface Shooting will not be possible. 41. �This is not a malfunction.
41. When the image is printed from the printer, a black bar appears at the bottom of the screen. 42. The power lamp blinks.
42. �The camcorder was turned on when the battery power was almost gone. 43. �If Audio Dubbing has been performed repeatedly on the same portion of the tape, disturbance to the sound may result.
43. There are disturbances in audio.
|
|
|
> |
|
