|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
 ;
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
;
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
20
EN
RECORDING (Cont.)
5S 5SD ANIM.
SCENE BEEP W IND CUT SOUND MODE I D No .
5S
ON OFF
48kHz 07
ON OFF OFF AUTO 48 kHz 32 kHz
END
I TEM ZOOM SW . SET SET BUTTON
This number will be necessary in the future when connecting the camcorder to a computer [01 to 99].
Sound
Sound signals can be sampled at 48 kHz or 32 kHz. 48 kHz�The camcorder is factory-preset for 48 kHz. This setting enables recording of stereo sound on two separate channels. *A tape recorded at 48 kHz cannot be used for Audio Dubbing. 32 kHz�This setting enables recording of stereo sound on four separate channels, and is recommended for use when performing Audio Dubbing.
Beep
The beep sounds when the power is turned on or off, and at the beginning and end of recording. ON�To activate the beep. OFF�To turn off the beep.
NOTE:
Beep is automatically turned on during Full Auto operation.
Wind Cut
When activated, this mode helps cut down on noise created by wind. AUTO�When shooting in high winds, noise is automatically reduced. �� � appears in the viewfinder. �The quality of the sound will change. This is normal. OFF�This function is disabled.
Scene (5-Second Mode)
This mode is enabled when the Power Dial is set to �5S�. 5S�Pressing RECORDING START/STOP allows you to take a 5-second �clip�. Press repeatedly for a succession of short recordings. 5SD�If you record a 5-second clip within 5 minutes after the previous one, the end of the old scene dissolves and is replaced by the new scene over a 2-second period ( pg. 25). ANIM. (Animation)�Each time you press RECORDING START/STOP, a 1/8-second recording is taken. By using an inanimate object and changing its position between shots, you can record the subject as though it�s moving.
NOTE:
The Wind Cut mode is disabled during Full Auto operation.
|
|
|
> |
|
