|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I received the manual in correct time. It was a perfect help for me.
;
excellent quality, contains circuits and scan quality, 226 pages
 ;
Great price for the manual and easy to locate on the site and download. I would buy again.
;
Very good copy of Manual, clear and easy to print off, arrived very promptly and reasonably priced. Thanks, I will use you again
;
The service manual when downloaded and printed out was clear and easy to read. The manual is complete with the schematic diagram and technical data. I occasionally require a manual and now having registered with this company I shall order from them in the future.
54
EN
TROUBLESHOOTING (cont.)
POSSIBLE CAUSES
26. �In places subject to low temperature, images become dark due to the characteristics of the LCD monitor. When this happens, the displayed colours differ from those that are actually recorded. This is not a defect of the camcorder. �When the LCD monitor�s fluorescent light reaches the end of its service life, images on the LCD monitor become dark. Consult your nearest JVC dealer. 27. �The light used to illuminate the LCD monitor causes it to become hot. 28. �This may occur when the surface or the edge of the LCD monitor is pressed. 29. �Certain Fade/Wipe effects, certain modes of Programme AE with special effects, �DIS� and other functions that cannot be used together are selected at the same time. 30. �The LCD monitor and the viewfinder are made with high-precision technology. However, black spots or bright spots of light (red, green or blue) may appear constantly on the LCD monitor or the viewfinder. These spots are not recorded on the tape. This is not due to any defect of the unit. (Effective dots: more than 99.99 %)
SYMPTOM
26. Images on the LCD monitor appear dark or whitish.
CORRECTIVE ACTION
26. �Adjust the brightness and angle of the LCD monitor ( pg. 12, 13).
27. The rear of the LCD monitor is hot.
27. �Close the LCD monitor to turn it off or set the Power Switch to �OFF�, and let the unit cool down. 28.
����
28. The indicators and the image colour on the LCD monitor are not clear. 29. The LCD monitor or viewfinder indications blink.
29. �Re-read the sections covering Fade/Wipe effects, Programme AE with special effects and �DIS� ( pg. 22, 24 � 26).
30. Coloured bright spots appear all over the LCD monitor or the viewfinder.
30.
����
|
|
|
> |
|
