|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Even if the PDF is a scan, I can read the information I need.
The price is affordable and the service (mail sending) is very fast.
Thanks ! Regards. William (Fan of Kenwood)
;
Very good quality original datasheet!I like this amazing website!!!!!!
 ;
Excellent just what I needed to replace the electrolytic caps and make this old gem a beauty again. Was as scan of the original photocopied service manual.
;
It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
;
I want to give you a real heads-up for your desire to enable such people as I to acquire the information I need to maintain the older types of equipment such as this Akai HXA351W. You do a swell job with all the processes you have to perform so I can have a legible, thus usable
document which does not send me crazy trying to figure out the blurry text of a bad copy.
Very well done, Thomas.
4.2
SYSCON SCHEMATIC DIAGRAM
NOTES :
For the destination of each signal and further line connections that are cut off from this diagram, refer to "4.1 BOARD INTERCONNECTIONS". When ordering parts, be sure to order according to the Part Number indicated in the Parts List.
TO VTR CPU
( ) MAIN SYSCON
TO REG TO VTR CPU, PC IF
5
JIG CONN.
(RESET DET) GND VOUT NC VCC
TO JACK CN501
TO JACK CN502
TO DSC/USB
TO MONITOR CN761
TO REG
4
TO PC IF TO CAM DSP
C
TO CAM DSP, AUDIO, TG/VDRV, OP DRIVE
TO REG
TO CAM DSP, ANA IN
UPD703039F1-A03
TO REAR UNIT CN1
TO ANA IN
3
C
TO V OUT
TO TG/VDRV TO CAM DSP TO TG/VDRV TO REG TO AUDIO TO CAM DSP
TO MONITOR CN761
2
TO OP DRIVE
TO AUDIO
TO JUNCTION CN571
TO ZOOM UNIT
TO CAM DSP
1
NO WEAR
y10186001a rev0
A
B
C
D
4-5
4-6
E
F
G
H
|
|
|
> |
|
