|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Absolutely perfect! I've been trying to understand how to use all or at least some of the features of the receiver and especially the remote.
;
Copy of genuine owners/operators manual, very useful
;
The manual was a perfect match and was exactly what I was looking for. I'm very satisfied with my purchase.
;
Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
;
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
10 EN
Power Zoom Lever
GETTING STARTED (cont.)
Grip Adjustment
1 Separate the Velcro strip. 2 Pass your right hand through the loop and grasp
the grip.
Recording Start/Stop button
3 Adjust your thumb and fingers through the grip, to
easily operate the Recording Start/Stop button and Power Switch and Power Zoom Lever. Be sure to fasten the Velcro strip to your preference.
Power Switch
Viewfinder Adjustment
Dioptre Adjustment Control
1 Set the Power Switch to � AUTO � or � MANUAL �
while pressing down the Lock Button located on the switch.
2 Turn the Dioptre Adjustment Control until the
indications in the viewfinder are clearly focused.
PAUSE
Shoulder Strap Attachment
1 Make sure the battery pack is removed. Following
2 1 3 Tripod Mounting
CAUTION
When attaching the camcorder to a tripod, extend its legs to stabilise the camcorder. It is not advised to use small sized tripods. This may cause damage to the unit by falling over. the illustration, thread the strap through the eyelet 1, 2. then fold it back and thread it through the buckle Repeat the procedure to attach the other end of the strap to the other eyelet 3 located under the Grip Strap. Confirm the strap is not twisted.
1 To attach the camcorder to a tripod, align the
direction stud and screw to the mounting socket and stud hole on the camcorder. Then tighten the screw clockwise. Some tripods are not equipped with studs.
|
|
|
> |
|
