JVC GRDVM90U
Owner's Manual

64

EN
POWER Switch Lock Button

DUBBING (cont.)
Dubbing Images Stored In A MultiMediaCard To A Tape
Images can be dubbed from a MultiMediaCard to a tape.

1 2 3
SNAPSHOT Button Fast-Forward Button (3) Rewind Button (2)
2

Load a MultiMediaCard ( ( pg. 12).

pg. 14) and cassette

To locate the point where you wish to dub a still image, play back the tape. Stop playback at the desired point. down the Lock Button located on the switch. Open the LCD monitor fully or pull out the viewfinder fully. Set the POWER Switch to � MEMORY � while pressing PLAY To select a still image to be dubbed, perform Index Playback ( pg. 49), Auto Playback ( pg. 47) or press 2 or 3 to select the image you wish. To engage Dub-Standby, press SNAPSHOT. The message �TO COPY TO TAPE PUSH "SNAPSHOT"� appears. While the message is being displayed, press SNAPSHOT again. The selected still image is recorded on the tape for approx. 6 seconds. �The indicator disappears when dubbing is complete.

4 5 6

3

Display

T O COP Y T O T A P E P US H " SNA PS HO T "

NOTES: � If SNAPSHOT is pressed in step 5 when the tape�s erase protection tab is set to �SAVE�, the message �COPYING FAILED� is displayed. � The XGA image is dubbed onto the tape at 720 x 480 pixels. � You can superimpose a print frame over the selected still image to be dubbed ( pg. 53) and dub it to a tape. After step 4, superimpose a print frame over the still image and go to step 5.